A1挤出机废料挡A1 extruder waste baffle guide groove
Copyright Claim
A1挤出机废料挡A1 extruder waste baffle guide groove
Boost
11
24
5
Print Profile(1)
0.16mm layer, 3 walls, 30% infill，50%速度
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
11
24
5
0
47
8
Released
Description
在左侧不靠墙的情况下防止废料乱弹，请按照图4放置模型否则可能配合不好
To prevent waste from littering on the left side without leaning against the wall, please place the model according to Figure 4, otherwise it may not fit well
Comment & Rating (5)
All
Print Profile
0.16mm layer, 3 walls, 30% infill，50%速度
Prints good but I had a huge Clogging because Poop got stuck in the Chute
0
Reply
Print Profile
0.16mm layer, 3 walls, 30% infill，50%速度
0
Reply
Print Profile
0.16mm layer, 3 walls, 30% infill，50%速度
0
Reply
Print Profile
0.16mm layer, 3 walls, 30% infill，50%速度
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld