Ender3 LED bar mounted on X axis. Needed accessories:

• 2 x 22awg wire
• 2 x 4mm bolt (8mm thread long)
• 2 x T-nut 4mm
• 1 x cable tie 2.5mm x 10cm
• 1 x cable tie 5mm x 20cm

In my case I used output from LM2596 buck converter where voltage is dropped from 24V to 11V. The same voltage is used for motherboard fan to make it quieter (because new BIGTREETECH SKR-mini-E3 doesn't need full speed fan).

LED bar is enough for mounting to X axis. There is also option to print cable clip so LED wire can be nicely inserted through existing cable and drive to motherboard case.

All parts can be printed without using support.

Creality

No