Search models, users, collections, and posts
Bat Wing Earrings with Tulle
Print Profile(4)
0.2mm layer, 2 walls, 100% infill
Designer
16 min
1 plate
0.2mm layer, 2 walls, Used two layers of rectalinear infill to create the Thule effect
21 min
1 plate
A1-0.2mm layer, 2 walls, 100% infill
15 min
1 plate
0.2mm nozzle, 0.1mm layer, 4 walls, 15% infill
36 min
1 plate
Open in Bambu Studio
Boost
502
1331
53
16
490
321
Released
Description
These simple bat wing earrings are meant to be printed with tulle fabric added halfway through the print. I actually think 4 pieces of tulle added in looks best. You can see that in the third and last picture where there are two wings with 1 tulle piece and two wings with 4 tulle pieces.
You have to trim all the tulle off the edges after, it can be tedious.
Once printed and trimmed, attach to chains and earrings.
You can iron the top layer, but I don't think you have to unless you were to print these in a lighter color.
[Also looks good printed in gold with tan tulle.]
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (53)