Chronos the keeper of Time, created using Hueforge

This time did some changes to the colours but can also be printed using grayscale.

As always, hope you like it and looking forward to see your makes :)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Chocolate Matte
• PLA Overture Chocolate
• PLA Overture Brown
• PLA PolyTerra Muted White
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #6 (0.56mm) swap to Charcoal Black
• At layer #8 (0.72mm) swap to Chocolate Matte
• At layer #10 (0.88mm) swap to Chocolate
• At layer #12 (1.04mm) swap to Brown
• At layer #14 (1.2mm) swap to Muted White
• At layer #20 (1.68mm) swap to White for the rest.