Pull Copter Finger Ring by agepbiz

agepbiz

Toys & Games>Other Toys & Games

Print Profile(4)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 35% infill

1 h

3 plates

4.6(105)

0.1mm layer, 3 walls, 35% adaptive infill etc.

1.1 h

1 plate

4.8(16)

0.2mm layer, 2 walls, 15% infill

37 min

1 plate

3.7(3)

0.2mm layer, 2 walls, 15% infill, no support

58 min

3 plates

Boost

291

509

161

864

845

Released

Description

Pull Copter Finger Ring

Assembled using M2x8 Hex Cap screws.

Commercial license

Do you want to sell prints of this model? You can purchase commercial licensing for this model by joining the Commercial license tier in my club

Subscribe or follow me on
Instagram:
https://www.instagram.com/agepbiz/
Twitter:
https://twitter.com/agepbiz

Print instructions

0,2mm
30mm/s
Support on the ring (I used support only from base)

ring

flying

pullcopter

Comment & Rating (161)

@Jackson.

Print Profile

⭐ Optimized (Reg) - 0.16 layer - High Quality

The print turned out really well! It also goes really high, I tried it from the floor, and I got it to hit my ceiling after a few tries 😅 Also, PLA is great for it! Though if you're a little rough on it, ASA or some other stronger filament might be better. I printed my 2nd one (shown in the picture) with ASA

@user_484812875

Easy to print.

@sherifkoumaiha

Print Profile

0.2mm layer, 3 walls, 35% infill

Thank you for your creation !

@danchappers

Print Profile

0.2mm layer, 3 walls, 35% infill

Printed well on my X1C, no issues.

@lloydhassell

This thing works great!! My 4 year old daughter loves it, she can launch the disc right across the room. I'm going to print another one but scale it up maybe 150-200%.