I created a set of Super Mario characters in watercolor for my son's room.

 One of these characters is Toad. It is created in Hueforge. 

If you use more than one of my characters, use the same filament for grey, black and white so that all the pictures match each other.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Matte Charcoal Transmission Distance: 0.6
    PLA BambuLab Matte Lilac Purple Transmission Distance: 2
    PLA BambuLab Matte Sakura Pink Transmission Distance: 3
    PLA BambuLab Matte Ivory White Transmission Distance: 4

Swap Instructions:
    Start with Charcoal
    At layer #11 (0.96mm) swap to Lilac Purple
    At layer #16 (1.36mm) swap to Sakura Pink
    At layer #17 (1.44mm) swap to Ivory White for the rest.