Spinning Top - No supports. Spins for 1 minute
Copyright Claim
Spinning Top - No supports. Spins for 1 minute
Boost
18
28
20
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
39 min
1 plate
Open in Bambu Studio
Boost
18
28
20
3
93
132
Released
Comment & Rating (20)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
I can’t get the bottom piece in all the way. I reprinted and did two. one broke while taking it off. Butvibwas able to get the bottom pieces in a lot easier.
(Edited)
The designer has replied
0
Reply
I'm sorry it's too tight! With my testing, and my filament on my A1 it was a nice fit. You can try to print just the tip at 99%.
0
Reply
Boosted
great spinner, had to hollow out the main body a bit more to fit the base but works perfectly 😃
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
spins nicely.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Cool Toy
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed a couple of these for my daughter and they were fun. Spins really well, good balance. printed easily.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked perfect. Waaay smoother than I thought.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bambu X1C - printed nicely. No issues A+
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great model. spins for around 1 minute on a smooth surface.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
© 2024 MakerWorld