ERYONE Cardboard Spool Adapter for AMS
Copyright Claim
ERYONE Cardboard Spool Adapter for AMS
Boost
116
209
101
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
41 min
1 plate
Boost
116
209
101
3
515
864
Released
Description
Dies ist ein Adapter für die Papppulen von Eryone. Damit lassen sich die Spulen benutzen ohne sie umzuwickeln und ohne die Gummirollen des Bambulab AMS zu beschädigen.
Layherhöhe von 0,2 ist vollkommen ausreichend.
This is an adapter for the cardboard Spools from Eryone. It allows you to use the Filament without wrapping them and without damaging the rubber rollers of the Bambulab AMS.
Layher height of 0.2 is fully sufficient.
Comment & Rating (101)
All
passt Perfekt.
The designer has replied
1
Reply
sehr gut :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Amazing design! I would love to see it be maybe 0.4 mm thicker for extra strength
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fit good, but a little bit too snug
0
Reply
Passt wie dafür gemacht. Danke für das Modell
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super Idee, mag ich lieber als nur die Ringe. Druckt wirklich schnell (A1 PETG).
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in 30 minutes on the X1C and fits perfectly and snug.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
thank you so much for this model, it Safes my prints and AMS
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect fit
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect fit and perfect print!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld