Crane inspirated support or stand for speakers. PETG was chosen, but no worries to switch to PLA.

NO SUPPORTS for print is needed. And no need to print all parts, but complex idea was to elevate and reduce the contact points with cones and some top the speaker rests on. You know HiFi ideas…

Each element has 2.2mm holes to easily accomodate 1.75 filament as support to fit guide for glueing. (just see photo)

You can stack two Elements each on other without breaking the crane design (with glue and 1.75 guide again).

Each element is 100x100x200mm and you can stack two to 400mm height ;-)

Top(deck) is 110x110mm

Speaker deck is 125x185mm

Cones are 5mm

You can fit 4 elements on 1 printing plate!

But you can see the 4 print profile I added and choose plate you want…

I hope you will enjoy the print and design at home.