Goblet of Fire - Harry Potter

Copyright Claim

Goblet of Fire - Harry Potter

Boost
28
38
4

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 17% infill
0.2mm layer, 2 walls, 17% infill
Designer
3.7 h
1 plate
4.5(4)

Boost
28
38
4
2
46
20
Released

Comment & Rating (4)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 17% infill
Strength Issue:I printed this in GIANTARM's Siler PETG and it came out great. I used Gloop's PETG Gloop to glue the two flat pieces together. The problem is the first time the cup was dropped 1 foot, it separated and there is no amount of regluing that would fix it. The model needs to have a tab extend down from the flat connector on the top part, and then a matching hole on the bottom part's flat connector. That would give the glue something to bite into versus 2 flat pieces right in the middle of the model.
0
Reply
Print Profile
0.2mm layer, 2 walls, 17% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 17% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 17% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.