Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
42
39
23
1
138
143
Released
Description
Simple but effective general purpose clip originally from dr_chunks. There was 2 very small manual support posts on the original I removed to utilize auto support as well removing the text for a cleaner result.
Comment & Rating (23)
All
Print Profile
0.2mm layer, 3 walls, 30% infill
I was confused by the supports for a second but great print!
The designer has replied
0
Reply
Yeah, I tried to make sure it could print as clean as possible for people. Thanks for the review!
0
Reply
Replying to @qwiktune
hella useful!
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Happy with this little clip. It's strong enough to keep snack bags securely closed but not so stiff that you struggle to take it on and off. I printed it with supports and those were a bit annoying to remove but definitely not a deal breaker. Printed with Anycubic PLA.
(Edited)
The designer has replied
0
Reply
Thanks for the review! =]
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
works great! thanks!
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
It's not too strong but that might be b/c I printed it in pretty small in PLA
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
perfect
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
works well!
0
Reply
works okay with Bambu ABS
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
fatta una versione di 1,5 cm... funzionante
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Strength Issue:the top half came off in printing
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld