Another part of “in the frame” series is Dreaming

Hope you like it and looking forward to see your makes :)

Might have some non-manifold edges again, a repair will solve the issue or just use the print profile

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA+ Sunlu White

Swap Instructions:

• Start with Black
• At layer #5 (0.48mm) swap to Charcoal Black
• At layer #7 (0.64mm) swap to Cement Gray
• At layer #10 (0.88mm) swap to Grey
• At layer #11 (0.96mm) swap to Light Gray
• At layer #14 (1.2mm) swap to White for the rest.