Clef Lightbox
Clef Lightbox
Boost
7
9
6
Print Profile(1)
0.16mm layer, 2 walls, 10% infill
Designer
5.8 h
3 plates
Open in Bambu Studio
Boost
7
9
6
2
18
17
Released
Description
Clef lighbox
Little decorative lightbox that shows your love for music.
Very easy to build. very little glue required.
Its meant to be battery powerd but also could be adapted to a usb connection.
The 3x AA batterycompartment can be glued into the stand.
I have used these for the job:
https://www.action.com/de-de/p/2548627/led-streifen/
While the backplate should be friction fit I have secured it with a little drop of hot glue.
The same with the battery box.
Happy printing!
Comment & Rating (6)
All
Print Profile
0.16mm layer, 2 walls, 10% infill
very nice print!
The designer has replied
1
Reply
Glad you like it! Thank you for sharing
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Take a look! Awesome!
0
Reply
Hello, i made this on my A1, it prints well but the support does not fit the piece, it simply does not fit.. my only change at your profile was the Wall generator from Classic to Arachne 10. But thanks for the model! I will sand it or cut it as little to fit..
The designer has replied
0
Reply
Hi, do you mean at the connector where the support structures are? Maybe you can share a picture? I would assume depending on how clean the supports can be removed it probably depends on the fit. I was able to push mine in without sanding.
1
Reply
Replying to @printerama
Yes, its something probably related with tolerances or supports as you mentioned..
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld