Target Trap - Airsoft only
Remixed by
Copyright Claim
Target Trap - Airsoft only
Remixed by
Boost
10
17
3
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
6.7 h
1 plate
Open in Bambu Studio
Boost
10
17
3
0
30
11
Released
Description
Bonjour
Je vous partage cette cible permettant de récupérer les billes.
Le modèle a été repris sur https://www.thingiverse.com/thing:4137977
Il permet d'utiliser des cibles de 140mm et de récupérer les billes facilement.
Pas besoin de supports à l'impression.
Fait en PLA avec une P1S.
Amusez vous bien
Good morning
I share with you this target allowing you to recover the pellets.
The model was taken from https://www.thiverse.com/thing:4137977
It allows you to use 140 mm targets and recover balls easily.
No need for printing supports.
Made in PLA with a P1S.
Have fun
Comment & Rating (3)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
not strong enough for my air soft waepen by 15 meters
The designer has replied
1
Reply
Merci pour le retour. J'ai testé ave un CM.127S MOSFET EDITION [CYMA], cela laisse des traces à 10 mètres. Par conte, avec mon AK CARBINE AT-AK01, idem, à 15 mètres ça a laissé des traces. Je pense qu'il faut remplir plus que 15%.
Quelle arme utilises tu ?
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
works well but even with 7 wall loops it can't handle 350 fps the back blows out what I did to remedy this was just printed a square of TPU and then fit it into the target and then glued it into place and now it works very well
1
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld