Dyson trigger lock
Copyright Claim
Dyson trigger lock
Boost
52
109
53
Print Profile(3)
0.16mm layer, 2 walls, 35% infill
Designer
26 min
1 plate
0.2mm layer, 2 walls, 35% infill
Designer
22 min
1 plate
0.16mm layer, 2 walls, 35% infill
38 min
1 plate
Boost
52
109
53
6
244
360
Released
Description
created a print-in-place trigger lock for my dyson because its very annoying to push the trigger the whole time.
Tested it with the v8 and v15 but should work with others too.
Tried PLA and PETG. Both worked fine.
No Support needed.
Comment & Rating (53)
All
not fit with v15 need small adjusment
The designer has replied
1
Reply
here is the working dimensions for mine dyson15
1
Reply
Strange. Tested it with the v15 of a buddy of mine and it worked
(Edited)1
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
Thus device works like a charm! My wife is super happy knowing this device will prevent her hands from cramping up. The print took about 28 minutes with PETG by Kingroon.
The designer has replied
1
Reply
And we all know: Happy wife, happy life 😋
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
Works great on my Dyson v15. Pretty snug
The designer has replied
1
Reply
Thank your for your rating and picture 😊
0
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
Works great!
1
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
Worked perfectly with my v15.
1
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
No flaw, works great.
1
Reply
Print Profile
0.16mm layer, 2 walls, 35% infill
Printed well with PolyTerra PLA, but unfortunately broke when I tried to mount it on my V8.
It's also not eactly obvious how far up you need to push this onto that little ledge. Button accessibility also seems greatly reduced now.
0
Reply
Boosted
Work with V8 thank you!
The designer has replied
1
Reply
Thank you for your comment and the boost 😍
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 35% infill
Thank you for the design. I scaled it slightly in the Z to fit my V11, and it works well. I will be sending you a Boost to reward your work.
The designer has replied
1
Reply
Thank you 😍
0
Reply
I don't understand what the little lever on the side does
The designer has replied
0
Reply
If you turn it towards the trigger it locks the trigger and you don't have to push it while using. Turning it back up stops it
0
Reply
Replying to @fabi.swob
Oh, I was just pushing the sheath down and it's tight enough it just holds it on it's own. Works great for me without the lever!
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld