WET PALETTE WITH ACCESSORIES
Copyright Claim
WET PALETTE WITH ACCESSORIES
Boost
12
27
3
Print Profile(1)
0.2mm layer, 2 walls, 25% infill
7.5 h
2 plates
Boost
12
27
3
0
31
18
Released
Description
Hello everyone, i made this model for helping my son to paint miniatures.
Its made specially for “REDGRASS” hydration paper , u can find it at amazon. https://a.co/d/1oWYXUg
Below the hydration paper u will have to fit a sponge like this one https://a.co/d/0mRrl10
Feel free to remix and improve the model.
Printed in PLA with 0.20mm layer height, no supports needed.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 25% infill
Bed Adhesion Issue:I tried every trick I know to get the lid to adhere to the build plate -- different filaments, higher temp, lower temp, hair spray, glue... I could never get it to adhere properly using this profile. I finally put a brim on it and added support and that seemed to solve the problem.
The designer has replied
0
Reply
i used golden pei Plate and didnt had any Problems. sry that it didnt worked for u. if a brim is the solution ill add one in my Profile.
0
Reply
Print Profile
0.2mm layer, 2 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld