Skadis Hammer Holder by mitsuhiko

mitsuhiko

Tools>Organizers

Print Profile(1)

All

0.2mm layer, 4 walls, 15% infill

Designer

1.2 h

1 plate

3.0(2)

Open in Bambu Studio

Boost

Released

Description

A simple holder for a Hammer on an IKEA SKÅDIS pegboard wall. Matches the general asthetics of my other holders.

This one is a bit trickier to print because the base is quite thin, but works well with tree supports.

skadis

hammer

pegboard

Comment & Rating (4)

@SnyTek

Print Profile

0.2mm layer, 4 walls, 15% infill

As you wrote the back part is quiet thin. It printed well but broke when I tried to mount it to the Skadis board.

The designer has replied

@mitsuhiko

Would be curious how that happened. I would not have expected that. Definitely study enough from my personal testing that I would not have expected it to break even with force. Still use mine.

@SnyTek

Replying to @mitsuhiko :

It could be that the holes of my board are smaller than ypurs so I had to press a bit to get the hooks in. In my case the back wall was not sturdy enough, and broke. 1 or 2 mm more would probably fix this.

@user_682600887

Print Profile

0.2mm layer, 4 walls, 15% infill