Foot Massage Roll
Copyright Claim
Foot Massage Roll
Boost
8
19
2
Print Profile(1)
0.16mm layer, 3 walls, 20% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
8
19
2
1
37
75
Released
Description
It is a foot massage roll. There are two grooves for 2 mm O-rings to get more grip on hard floor. You might print this Hex-Ring from TPU instead of using an O-Ring but O-ring is recommended.
As the Slicer has some difficutlies to process the step file correctly I added a stl file wich is recommended to use.
Comment & Rating (2)
All
The print profile is no longer public
Prints as expected. There was a little bit of layer adhesion issues on the underside of the bumps, but I just used default Bambu settings to print. I’m sure I could get better results if I tinkered with it. good functional part
0
Reply
The print profile is no longer public
(Edited)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld