Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 8% infill
Designer
16.8 h
2 plates
Open in Bambu Studio
Boost
43
112
3
3
37
7
Released
Description
Print the top pieces first. There should be a pause on the main body to add the top. Add the top cover before the towers finish. You will not be able to remove it, but it does move for easier access. Print in petg especially if you are using a heat lamp or pad.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (3)