Minecraft Cube

THANK YOU I HOPE YOU ENJOY PLEASE CHECK OUT THE REST OF MY HUGEFORGE IF YOU HAVE A REQUEST,

 PLEASE MESSAGE ME.

WARNING… LET IT COOL DOWN BEFORE REMOVING OR IT WILL BE WARPED.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x125mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Tough Gray Transmission Distance: 2
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Blue
    At layer #11 (0.96mm) swap to Gray
    At layer #15 (1.28mm) swap to Jade White for the rest.