Electric Tooth Brush Head Holder by Speedy 3d

Speedy 3d

Household>Other House Models

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 20% infill

Designer

1.7 h

1 plate

4.9(15)

0.2mm layer, 2 walls, 20% infill

1.7 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

142

Released

Description

If you've ever found mold like growth on your tooth brush heads then they need a stand to air out on. This is why I put forth effort to make a perfect slim design to hold up to 2 heads. It includes a drip tray for excess water to run out and keeps the underside of the brush head clean. Requires minimal support for an easy removal.

electric toothbrush holder

electric toothbrush travelling case

bathroom countertop organizer

Comment & Rating (31)

@RockieOnly1

Print Profile

0.2mm layer, 2 walls, 20% infill

this printed great.

The designer has replied

@Speedy3d

Thanks for the feedback and I hope it comes in handy

@Chris1974

Nice holder. But I see you don't have colored rings on your brush heads... How do you tell them apart? I have a 3D model for that on Makerworld you know?

The designer has replied

@Speedy3d

Well, normally, I mark them with a sharpie, but I just use two new ones for the photo shoot

@Chris1974

Replying to @Speedy3d :

Why don't you try this instead: https://makerworld.com/en/models/379450

@Speedy3d

Well before I knew it, it was done printing, and it seems to fit really good. Thank you for the suggestion and hope you enjoyed your print as well.

@bryanf

Print Profile

0.2mm layer, 2 walls, 20% infill

Works great, thanks

The designer has replied

@Speedy3d

glad you liked it

@martynjhogg

Print Profile

0.2mm layer, 2 walls, 20% infill

worked first time

The designer has replied

@PrintedByJohn

Thanks for your feedback.

@busy101

Print Profile

0.2mm layer, 2 walls, 20% infill

worked perfectly

(Edited)

The designer has replied

@Speedy3d

I hope the product works great in the future, and if you have a good profile for it, make sure to put it down below and happy printing!

@user_2577114267

Print Profile

0.2mm layer, 2 walls, 20% infill

The designer has replied

@Speedy3d

Well, hope the toothbrush works out well for you and keeps the mold out of the bottom of the brushes. Make sure to post a profile below. and happy printing.