Lighthouse 7.1.4
Copyright Claim
Lighthouse 7.1.4
Boost
55
88
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
9.8 h
5 plates
Open in Bambu Studio
Boost
55
88
16
3
165
180
Released
Description
Lighthouse 7.1.4
Comment & Rating (16)
All
Nice design 😎
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
2
Reply
HI,
thank you very much, it's beautiful
(Edited)1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect! Printed without the base
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I printed two since I wasn’t sure which colors would look better and both came out nicely. Very nice model.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This was a fun print. I do wish that the house part would fit a little better /deeper into the "ground" base. Also, I would prefer that the top parts of the tower "locked in" somehow.
I am going to print out a round plate to put under the tower so that it can hold an LED tea light near the top.
I had to reprint the roof at 1/2 speed due to some faults on one edge (Bambu P1S, Bambu PETG Blue-Grey). The 2nd print came out fine.
0
Reply
Boosted
Thank you so much for the model. It looks amazing
The designer has replied
1
Reply
Thank you very much 😊
0
Reply
Realy, the most beautiful lighthouse in this web!!
The designer has replied
0
Reply
You are very kind and I thank you very much, and thank you for your feedback
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Realy, the most beautiful lighthouse in this web!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Had fun printing the and wiring with LED lights.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
THANK YOU VERY MUCH
(Edited)1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld