Framework 3 Card Case

Adapted from the 2 card design by Nawyandt on Printables, this Framework 3 expansion card case holds 3, standard, expansion cards. If you are looking for a 2 card version or 2 cards + Ethernet card I highly recommend you check out the original designs by Nawyandt!

The files in this model contain the upper/lower case and middle holder part. This case requires no extra hardware, and the two halves can be printed with no supports with the holder part being printed open end (where the slots are) down with supports.

To assemble, put the holder part into the bottom shell (the one without the logo) by sliding one peg through the open notch and the opposite peg up into the hole. Then shift the holder part over and down so both pegs are in the holes. The smaller, guide pegs on the holder piece should be on the top (open) side of the case. Then mesh the two case sides together by prying one side open a little bit utilizing the flex of the plastic.