I created a set of Super Mario characters in watercolor for my son's room. 

One of these characters is Mario. It is created in Hueforge.

 If you use more than one of my characters, use the same filament for grey, black and white so that all the pictures match each other.

See my other paintings

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Matte Charcoal Transmission Distance: 0.6
    PLA+ Sunlu Red Transmission Distance: 6
    PLA BambuLab Tough Vermilion Red Transmission Distance: 3
    PLA META Sunlu Grey Transmission Distance: 5
    PLA BambuLab Matte Ivory White Transmission Distance: 4

Swap Instructions:
    Start with Charcoal
    At layer #8 (0.72mm) swap to Red
    At layer #10 (0.88mm) swap to Vermilion Red
    At layer #11 (0.96mm) swap to Grey
    At layer #13 (1.12mm) swap to White for the rest.