I plan to create some models with the same “living-in-the-frame” concept and style.

This is the first one and i hope you like it.

Update 25/8/2023: Added 6mm depth version, the original version is 2mm depth. The “deep” new model will take significantly more time to print and more filament.

Both models might show an error for "non-manifold edges”, i did a repair using orca slicer and although it tool some time, it fixed the errors. If you see empty spaces inside the frame, the model will not print correctly. You can also use the print profiles which include the corrected model versions

For Model with 2mm depth

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA+ Sunlu White

Swap Instructions:

• Start with Black
• At layer #5 (0.48mm) swap to Cement Gray
• At layer #8 (0.72mm) swap to Grey
• At layer #12 (1.04mm) swap to Light Gray
• At layer #16 (1.36mm) swap to Bone White
• At layer #18 (1.52mm) swap to White for the rest.

---------------------------------------------------------------------------------------

For Model with 6mm depth

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #12 (1.04mm) swap to Charcoal Black
• At layer #16 (1.36mm) swap to Cement Gray
• At layer #20 (1.68mm) swap to Gray
• At layer #24 (2mm) swap to Light Gray
• At layer #38 (3.12mm) swap to Bone White
• At layer #42 (3.44mm) swap to White for the rest.