Zeus
Copyright Claim
Zeus
Boost
88
124
12
Print Profile(2)
0.08mm layer, 2 walls, 100% infill
Designer
6.9 h
1 plate
4 Colors AMS, 0.08mm layer, 3 walls, 100% infill
7.9 h
1 plate
Boost
88
124
12
0
220
49
Released
Description
A painting of Zeus, sitting on his throne in a big 22x22cm
Had a rough time with the lights on this model so decided to go with fewer colours.
Looking forward for your makes and i hope you like it :)
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
- PLA Overture Black
- PLA Overture Cement Gray
- PLA+ Sunlu Gray
- PLA+ Sunlu White
Swap Instructions:
- Start with Black
- At layer #6 (0.56mm) swap to Cement Gray
- At layer #9 (0.8mm) swap to Gray
- At layer #14 (1.2mm) swap to White for the rest.
Comment & Rating (12)
All
good
The designer has replied
0
Reply
Great Print, thank you for sharing :)
0
Reply
prints amazing!
1
Reply
incredible it looks so much better in real!
The designer has replied
1
Reply
I agree...photos are not helping these models 😄
0
Reply
Print Profile
4 Colors AMS, 0.08mm layer, 3 walls, 100% infill
niceeeee one
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
There were some warps, but the model isn't the problem. Printed correctly on second try
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
Wunderbarer Druck, kam
perfekt raus. Meiner Meinung nach wäre der Brim nicht nötig, dieser lies sich auch nicht besonders gut entfernen.
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
1
Reply
Print Profile
4 Colors AMS, 0.08mm layer, 3 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 100% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld