I saw this magnificent resting hippo and decided to remix it into an incense holder using two holes in its noze.

It's not really long, it was enough for my incense, you may want to scale it up a bit in width if you're using long incense.

If you really want a nice finish, use adaptive layer to smooth the top curve.

I did not assemble both part for easier prints, and used glue. But you could try to print it in one go without support or limited support. Or use the connector feature.

Photo shows seam aligned in the front, I've rotated the hippo to align them in the back instead :)

Hoping you'll like it!