Cat Toy Ball in Ball
Copyright Claim
Cat Toy Ball in Ball
Boost
21
34
25
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
21
34
25
0
146
142
Released
Comment & Rating (25)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Just took a bit of focus to use the exacto knife. Came out great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
inside ball was a little too small and easily slips out of some of the holes.
The designer has replied
3
Reply
Thank you, I scaled it up so it shouldn't fall anymore
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Der innere Ball fällt aus dem Loch des großen Ball.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
inside ball was too small, fell out during printing. But my cat still loves the ball. because I was printing from my phone, I could not resize it.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice! printer great and our cat loves it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed fine ... but the ball fell out
0
Reply
The small ball falls out easily but our cat still likes playing with the larger ball!
0
Reply
Same as others, internal ball is too small, just slips out. May be a choke hazard :(
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
my cats liked it
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld