Gridfinity Battery Boxes AA & AAA
Copyright Claim
Gridfinity Battery Boxes AA & AAA
Boost
52
161
31
Print Profile(3)
0.2mm layer, 2 walls, 10% infill
Designer
6.4 h
1 plate
Only AA battery box
2.9 h
1 plate
Only AAA battery box
3.2 h
1 plate
Open in Bambu Studio
Boost
52
161
31
5
285
189
Released
Description
Two Battery Boxes for AA & AAA Batterys.
Prints like a charm.
Each box can be printed individually.
I usualy print my Gridfinity boxes with a coler codes Brim, but you can, of course, print it in one solid colour an material.
Comment & Rating (31)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Great addition to gridfinity
The designer has replied
1
Reply
thank you for sharing and the pictures.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Works great! The edges are a bit tight (probably cause of the brim) but they'll still fit -- just requires a bit of force.
(Edited)
The designer has replied
1
Reply
thanks for sharing your experience
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Good print, the fit of the batteries on the sides, especially the corners, is very tight due to the overhanging ledge but it works :)
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
nice simple storage
(Edited)
0
Reply
Print Profile
Only AA battery box
0
Reply
The top lip makes the outside rows unusable on both the AA and AAA. Are batteries a different where I'm at? I'm in the US. And if you force it in there it damages the coating on the battery. Please address this problem.
The designer has replied
0
Reply
Thanks for your comment. As shown on the pictures it works in other cases, but I will look into that.
0
Reply
Replying to @MakerBunny
Another possibility is that I use rechargeable batteries and have noticed that some manufacturers, specifically Amazon Basics batteries, are noticeably bigger in OD. I would be happy to measure my batteries and share that with you if you are interested.
1
Reply
Replying to @twoks
sure. that would bei nice to compare sizes.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
awesome print thanks
The designer has replied
0
Reply
Thank you 😀
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
the outside pockets to tight for batteries to fit
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
very good but tight fit for the batteries at the edges
0
Reply
License
This user content is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld