Gridfinity MDS Remix for Multiboard Remixed by Chris3DPrints

Remixed by

Chris3DPrints

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

13.3 h

3 plates

4.7(11)

Open in Bambu Studio

Boost

213

192

206

Released

Description

This is a remix of Chipp Walters Gridfinity Modular Drawer System. I created a special peg for the peg board and added slots to the back of the case, this allows you to slide the caes on and off the Multiboard easily.

*** Update 2024.01.18 ***

Updated the Peg-Slide-Slim stl file to be a little thicker on the bottom so it adds more contact to the case.

gridfinity

multiboard

Comment & Rating (22)

@rekk

Print Profile

0.2mm layer, 2 walls, 15% infill

Works and looks great. I had a bit of warping but it's not visible and doesn't effect anything (I should have turned off the aux fan while printing the cases).

The designer has replied

@Chris3DPrints

Looks nice, I like the pot. Yeah I had some cooling issues printing the Multi Board, same spot every time, I think it was the same issue. Thanks for the review.

@luna_is_my_dog

ahhhhh man, the marble looks great.

@TheNotoriousBSP

2nd time attempting to print. black PLA, Bambu support PLA, X1C. what am I doing wrong? I’m new 😂First attempt spaghettid on me. this second one frayed and lifted on the edges.

(Edited)

The designer has replied

@Chris3DPrints

You don’t need support. Post a pic of what orientation it’s trying to print in the slicer.

@Chris3DPrints

From the photo it look like your are printing it in the wrong orientation. Print it with the back laying down, this way you don't need supports. It should start printing the back then the sides and dividers as the print goes up.

(Edited)

@Primalghost

Print Profile

0.2mm layer, 2 walls, 15% infill

Prints perfect and fits onto multiboard

The designer has replied

@Chris3DPrints

Thanks for the review, looks nice.

@Fitchtastic

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Awesome addition to my multiboard. printed easily and turned out fantastic

The designer has replied

@Chris3DPrints

Thanks for sharing your print, when I get time I want to remix the drawers so they don’t pull all the way out. Already spent 3 hours re sorting all my m2, m3, m4 nuts, bolts and washers when removing the case to move to my table and the drawer slid all the way out. So yeah, be careful.

@LambertPrime

I love this thing. it was exactly what I needed for all my small parts. I messed up the drawer pulls, but the best part is those are easily re-printable.

(Edited)

The designer has replied

@Chris3DPrints

yeah, just be careful if your kids pull the drawer all the way out after sorting all the screws, nuts and washers and they end up all over the floor and you spend the next 3 hours re sorting them all again. When I get more time will do a Remix with little stoppers for the drawers.

(Edited)