Hardware needed:
I have created 2 Versions.
“nail” Version is using a 3mm Nail as axle.
“bolt” Version is using printed bolts. There you need to check which bolt suits you best. I made several slightly different diameters.
There are 2 different magnet positions forseen. I use the inner ring. But it depends on the friction and the power of your magnets.
Just try it yourselfe if you use inner or outer or both rings.
Take care that you glue in the magnets in the same polarization.
I printed the “dice” with 66% infill to give it a nice weight.
The sides are very tight fitting to the basement. No clue needed. Just push a bit harder.
You need to duplicate the side and mirror it along x-axle to see the dragen from both sides in the same direction..
Inspired by: https://www.printables.com/de/model/466133-rolling-dice-remix but completely self created, no remix
Dragon by Freepik -→ https://de.freepik.com/vektoren-kostenlos/drachen-silhouetten_786264.htm#page=2&query=svg%20dragon&position=1&from_view=search&track=ais&uuid=fbe070b3-7371-4221-ad83-ed341e2c33e0