This is a remix of the model N3RD Solutions posted, so a big thank you to him for making the original.

Single version: https://makerworld.com/en/models/146174#profileId-159144

Triple version: https://makerworld.com/en/models/146168#profileId-159136

This remix was created to fit the double switch I have in my bathroom where I thought this model would best fit. The changes made are the following:

• First the obvious - made the model compatible with a double-switch
• Added a hollow back to better fit that hardware
• Rounded the edges a bit to give it a more finished look
• Deepened the screw holes to have a more flushed look

I have added the 3mf file of the project that includes custom-painted supports as well as my model-specific tested support settings that make it relatively easy to take off with the printer clippers. Would appreciate any feedback as I'm a newbie designer.

*Disclaimer* 

Normal switch covers are typically fire resistant while normal pla is not. You are responsible for your own safety as am I. The chances of an electrical fire are slim but never zero. Do what you will with that information.