Appears to be a stock default print profile; uses grid infill, inconsistent settings for top and bottom layers, infill/model orientation is not well aligned - causing many pinhole fills (surface gap infill). Can't really fault the last one too much since the model is a whole bunch of rounded edges. I tried printing this profile twice on the Cool Plate and had two corners come loose on me, both times. Plate was clean, perhaps it was my cheap Sunlu filament I was trying to use up. Second attempt was made with a few changes on plate orientation but otherwise left alone. I scrapped them both because the print would have eventually failed. Gave up and printed the model with significant changes to use transparent filament at very slow speeds and no infill at all. Found the insert to have very generous clearance - it slides in and out of the holder if nudged. Put some double-sided tape inside the foot of it to keep it in place. It's a neat design, but at least with PLA all the pieces seem to slide around a lot and it doesn't stay together very well when touched.

sieht super aus und funktioniert tadellos 👍☺️

Printed very well and functions great.