Car Coin Cup Holder [US/EU Sizes]

Warning: Printing in PLA can lead to a soft print that may sag or deform in the hot sun. Your local area and its average midday temperature will determine if PLA is viable for you. Where I am, PLA works fine. If you print this in a more temperature-resistant material, you can probably lower the wall count to 2 and be fine

If you want me to adjust the sizes for your own countries coin sizes, please just let me know.

Both profiles are set with 4 walls and 10% cross-hatch infill. Both also have a modifier cube at the top set to 99% infill to marginally increase the strength of the finger-grabber section. Additionally, you can do what I did and put a key ring on the top, like the split-ring key chain available on Maker Supply; See the parts section below.

The US print profile has these coins: 

• 25c, 5c, 25c, 25c, 10c

The EU print profile has these coins:

• €2, 20c, €1, 50c, 10c

Also Note: I marked it as non-commercial so please get in touch with me if you would like to sell it.