Drybox Plug with Filament Buffer - for PTFE / Bowden Tube
Copyright Claim
Drybox Plug with Filament Buffer - for PTFE / Bowden Tube
Boost
18
56
20
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Open in Bambu Studio
Boost
18
56
20
1
95
65
Released
Description
A simple print that is used to close the end of a PTFE/Bowden tube. The special feature: The plug has a buffer for the filament so that you can easily pull it out of the tube after you pull the plug off.
I use this plug with my (dyna) dryboxes. I no longer have to open them to use the filament. Simply pull off the plug, grab the filament and insert it into the printer.
Features
- Fits 4mm tubes
- Easy 10 min print
- Only 1.5 grams of filament
Print settings
- No special settings required
- Works perfectly with PLA
- If you are unsure about adhesion: Use Brim! (I printed on a Textured PEI Plate and had no problems)
Comment & Rating (20)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
had to scale to 95% to get it to fit snug.
model is far to loose.
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Nice!
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Does not fit snug on pfte tube...at least with my printer settings. I'll need to remix to fit better.
1
Reply
exactly what i need! thank you
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Simple. I have printed quite a few of these for my dry boxes. The fit is nice and tight, but not too tight.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
great plug, put on all my detoxes.
0
Reply
Question; what do you do when switching filaments? Do you have to open your dry box to manually rewind it?
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Fits nice and snug. Printed perfectly in Sunlu PLA+. Thanks!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld