RG35XX Plus Grip (Updated) Remixed by randombran

Remixed by

randombran

Toys & Games>Other Toys & Games

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 10% infill

Designer

2 h

1 plate

5.0(4)

(Tighter fit with ridges) 0.2mm layer, 3 walls, 10% infill

Designer

2.1 h

1 plate

Open in Bambu Studio

Boost

Released

Description

UPDATE: Included another version of the grip that includes some ridges inside where the device goes. It holds the device much tighter where it will not slide out by accident. It did create some small scratches on the side of RG35XX Plus but much prefer this version to the original.

Remix of a great grip for the RG35XX top fit the Plus model. I changed the dimensions to fit the RG35XX Plus and also removed the bottom to allow charging while playing and cut off a piece to allow cable strain relief. Must use supports!

Please be careful as it isn't too tight on the device so it is capable of sliding out if angled downward.

Comment & Rating (7)

@MountainMantis

Print Profile

0.2mm layer, 3 walls, 10% infill

Printed great! Supports came right off. I had some felt tape that I used on the inside and it holds the device great as well as keeps it from getting scratches. Printed in Hatchbox Gray PLA.

The designer has replied

@randombran

Looks good! The felt tape is a solid idea. Will have to add that to mine.

@Painzub

does it fit the normal rg35xx? or only the plus?

The designer has replied

@randombran

I believe it only fits the plus. I can’t confirm as I only have the plus. If you print the model that I remixed (should be linked on the page), that’s the one modeled to fit the regular.