One Hand Book Reading Helper
Boost
45
84
21
Print Profile(2)
0.28mm layer, 4 walls, 15% infill
Designer
21 min
1 plate
0.28mm layer, 4 walls, 15% infill
19 min
1 plate
Open in Bambu Studio
Boost
45
84
21
0
187
133
Released
Description
- sides are flat, to not put pressure on pages when reading
- angle of the helper allows to keep a decent angle of the book, without the need to overly pressure the book
- only 6.8 grams of material needed
Printing instructions:
- PLA as a material choice is sufficient
- print on its side, no brim, no supports
- use max layer height possible - pictured is 0.32mm @ 0.4mm nozzle
- use 4 perimeters
Version history:
v1.0
9.1.2024
- initial release
Comment & Rating (21)
All
Print Profile
0.28mm layer, 4 walls, 15% infill
wife and daughter love these thanks. printed in Trans PETg.
The designer has replied
0
Reply
Beautiful!
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
works great !
The designer has replied
0
Reply
Many thanks!!
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
Great print that works well and prints fast.
(Edited)
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
Nice print
My girlfriend really likes it.
The designer has replied
0
Reply
Thank you very much 😊
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
works, but lost it quickly
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
even better in two colors
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
very nice
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
A perfect print with no defects. The first layer was great, keep up the good models.
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
wife love's it thanks
0
Reply
Print Profile
0.28mm layer, 4 walls, 15% infill
Easy and fast print, works well
(Edited)0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld