Low poly Yoshi with stand by Forest87

Forest87

Art>Sculptures

GIF

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

1.1 h

1 plate

4.5(57)

Fixed, A1 mini adaptation

1 h

1 plate

4.4(12)

Open in Bambu Studio

Boost

181

341

534

454

Released

Description

Line art low poly sculpture of Yoshi (from Super Mario series), with stand!
Decorate your home with your favorite character. Give a touch of personalization to your collection!

If you like this model, maybe you might like these too!

Comment & Rating (79)

@Nalin

Print Profile

0.2mm layer, 2 walls, 15% infill

Great print, would benefit from being slightly thicker as right after this picture, Yoshi's nostril fell off. Could possibly have been due to print being slightly warm when lifted from the bed.

(Edited)

@3DPrintsThisWee

Print Profile

0.2mm layer, 2 walls, 15% infill

Came out awesome! I used the creators print profile (with no adjustments) and didn't have any issues. Very nice design.

@Jackomo

Print Profile

0.2mm layer, 2 walls, 15% infill

Cool print I'm satisfied. But tolerance is not perfect with the stand. Had to clip less than 1mm. But overall totally solid.

(Edited)

The designer has replied

@Forest87

Thank you for your comment. I Will correct the base tollerance and reupload the profile and model.

@cm_dubz

Print Profile

Fixed, A1 mini adaptation

a little brittle but overall good

@Pipoprinter

Print Profile

Fixed, A1 mini adaptation

Very nice print, some minor mistakes. The „foot“ of Yoshi, which goes in the plate, is 1.5-2mm to long so you have to cut it to fit. Printed with Polyterra Charcoal Black PLA

@3DunkPixelPrint

Print Profile

0.2mm layer, 2 walls, 15% infill

petits défauts lors de l'impression dû a un manque d'adhérence du plateau.

@Rickyson90

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed Perfectly. Looks amazing :)

@Nalin

Great model, came out with zero adjustments necessary on my P1S. Would thicken this up slightly if I was printing it again as it is extremely delicate.

@kevin_hagen

Print Profile

0.2mm layer, 2 walls, 15% infill

Strength Issue:Used PLA lines are missing or broken, not good. I changed nothing.

The designer has replied

@Forest87

good morning, as you can see from the images of my print, I have not had any problems. Some lines stop before rejoining the edges and this is intentional in the model. As for the printing errors you reported, they can be attributed to your filament or your printer.