Tie Fighter Stand - Fab365
Copyright Claim
Tie Fighter Stand - Fab365
Boost
14
20
6
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
41 min
1 plate
Open in Bambu Studio
Boost
14
20
6
0
50
18
Released
Description
Hello Makerworld Community,
Here comes a stand/base for the Tie Fighter model from the Fab365 website.
The model itself can be downloaded for free from Fab365 if you are not yet registered on the website.
Hallo Makerworld Community,
hier kommt ein Ständer/Sockel für das Tie Fighter Modell von der Fab365 Website.
Das Modell selbst kann kostenlos bei Fab365 heruntergeladen werden, falls ihr noch nicht auf der Website registriert seid.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
Printed with Brim.
Fits perfect in the back without glue.
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
The attachment point to the rear of the model needs to be a bit tighter.
The designer has replied
0
Reply
Unfortunately I can't do anything about that, that's because of the original model from Fab365.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
The stand printed flawlessly… might have to add glue where it connects though as the space is shallow.. .
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld