harry potter wand (miriam)
Copyright Claim
harry potter wand (miriam)
Boost
223
434
85
Print Profile(5)
Wand_Miriam 20 cm
Designer
53 min
1 plate
240mm very big 0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
16 cm Wand_Miriam
Designer
39 min
1 plate
0.2mm layer, 2 walls, 15% infill
51 min
1 plate
Click to see more
Boost
223
434
85
3
890
754
Released
Description
harty potter wand
Comment & Rating (85)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Mostly impressed by the supports, delicate removal but they definitely did the job. eSun PETG. felt it needed a bit of a sand, landed on the weathered look
3
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very good.
(Edited)
2
Reply
Print Profile
Wand_Miriam 20 cm
printed very quickly and looks great. I just need to clean the supports up and do some buffing. Great print!
Bambu Labs A1
Inland pla white from Microcenter.com
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice!
0
Reply
Print Profile
240mm very big 0.2mm layer, 2 walls, 15% infill
awesome
0
Reply
Print Profile
240mm very big 0.2mm layer, 2 walls, 15% infill
the model is great, my issue was my fault alone, I am admittedly new to this. I saw the tree supports and said hey this would be a good test of the support filament that came with the printer, so I told it to use that. well the wand turned out fine, at the tip the support material pealed off super easy, but it was like things got confused when it got to printing the back and middle of the wand. u can see from the photo, it mixed the support material in the model
0
Reply
Print Profile
Wand_Miriam 20 cm
(Edited)
1
Reply
这是谁的魔杖
The designer has replied
1
Reply
Miriam Fig's wand from Hogwarts Legacy
(Edited)0
Reply
Print Profile
240mm very big 0.2mm layer, 2 walls, 15% infill
Poor print, very thin walls. Support material inclusions into print. Wall material pulls off when removing supports resultiong in unusable print afer hours of printing. A waste of filament.
The designer has replied
0
Reply
Calibrate the printer is the only thing I can tell you. Thousands of people are satisfied with the result. cut the supports with pliers delicately and you will see how you don't break things
0
Reply
love it
1
Reply
License
This work is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld