Undead Pirate in the frame by DonMatis

DonMatis

Art>Other Art Models

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.08mm layer, 3 walls, 100% infill

Designer

3.5 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

In the frame series next member is the Undead Pirate

Hope you like it and looking forward to see your makes :D

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

PLA Overture Black
PLA Overture Cement Gray
PLA+ Sunlu Gray
PLA Overture Light Gray
PLA+ Esun Bone White
PLA+ Sunlu White

Swap Instructions (but feel free to use less colours or different) :
Start with Black

At layer #6 (0.56mm) swap to Cement Gray
At layer #8 (0.72mm) swap to Grey
At layer #12 (1.04mm) swap to Light Gray
At layer #16 (1.36mm) swap to Bone White
At layer #17 (1.44mm) swap to White for the rest.

hueforge

Comment & Rating (3)

@Astaroth

I want to compliment you because they are wonderful, but I don't understand one thing, how can I print them if I have AMS with 4 colours? don't you use it? does the printing stop and you change the reel every time? Thank you in advance for the information

The designer has replied

@DonMatis

There are two ways to print with only 1 AMS: 1. Use preview and 4 colours (black, gray, light gray and white)...you will have very good results with all my grayscale paintings 2. Use 8 colours by defining only 4 on bambu/orca slicer. For example you will use black twice on slicer but you will replace it with for example light gray after the first black it finishes. It will not look good on slicer preview but it will make is possible to print even with more colours and since you swap them after each colour finishes you don't need to pause or anything.

(Edited)