(no rubber band) OTF加固版
Remixed by
Copyright Claim
(no rubber band) OTF加固版
Remixed by
Boost
368
674
108
Print Profile(4)
![[See Video to Build]: 0.16mm layer, 3 walls, 10% infill](https://makerworld.bblmw.com/makerworld/model/US8878f703109bde/46722081/instance/2024-01-13_a07a914a0822.jpg?x-oss-process=image/resize,w_100/format,webp)
[See Video to Build]: 0.16mm layer, 3 walls, 10% infill
2 h
2 plates
Single plate AMS
4.1 h
1 plate
![[1 Plate, Low Waste]: 0.16mm layer, 3 walls, 10% infill](https://makerworld.bblmw.com/makerworld/model/US8878f703109bde/46722377/instance/2024-02-01_751fd20095ed1.jpg?x-oss-process=image/resize,w_100/format,webp)
[1 Plate, Low Waste]: 0.16mm layer, 3 walls, 10% infill
1.7 h
1 plate
Single Colour, 0.16mm layer, 3 walls, 15% gyroid infill
1.4 h
1 plate
Open in Bambu Studio
Boost
368
674
108
8
2.7 k
1 k
Released
Comment & Rating (108)
All
非常巧妙的结构
1
Reply
Print Profile
[See Video to Build]: 0.16mm layer, 3 walls, 10% infill
Turned out great in Polymaker Polylite ABS.
I’m going to fuse the spring to the blade to make it a single piece after assembly.
1
Reply
Print Profile
Single plate AMS
Very good action works 98% of the time
0
Reply
Print Profile
Single plate AMS
Works really fine and smooth
0
Reply
Amazing design to print👍
This video will help you to see the function of this model: https://youtu.be/3IeGDW97KRA
0
Reply
Print Profile
Single Colour, 0.16mm layer, 3 walls, 15% gyroid infill
this is a good print minor issues such as blade does not always fully extend
0
Reply
Nice mechanism, works well
0
Reply
Print Profile
[See Video to Build]: 0.16mm layer, 3 walls, 10% infill
Works well. Just the spring could be stiffer but I printed in PLA so I will try other materials.
Note: Male sure you don’t mode you hand when retracting. It needs the stiffness of you body to lock back into place. If it gets stuck in the middle just filling extend the blade with your hand until it locks.
0
Reply
Print Profile
[See Video to Build]: 0.16mm layer, 3 walls, 10% infill
guter Druck, funktioniert leider nur kurz mit PLA.
0
Reply
Print Profile
[See Video to Build]: 0.16mm layer, 3 walls, 10% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld