Search models, users, collections, and posts
Mini fuse puller
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
5
10
3
0
33
30
Released
Description
A mini fuse puller that works well with 5x20 mm fuses and 6x32 mm fuses. It was created as i needed a simple tool to pull fuses from my pinball machines, and the ones made from other users seemed too over-complicated or didn't work for me. This does the job perfectly. Just insert below fuse, and pull or “tilt” the tool to pull out each end of the fuse.
Uses about 2 grams of filament and prints in a few minutes.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)