Multiboard Tape Measure Storage Clip
Copyright Claim
Multiboard Tape Measure Storage Clip
Boost
32
118
17
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
40 min
1 plate
Open in Bambu Studio
Boost
32
118
17
0
182
127
Released
Description
Looking for your tape measure again?
Having your tape measure on your Multiboard, you'll never spend time looking for your tape measure again. Better yet, put a Multiboard up in every room with tape measures on each so one will always be within arms reach.
Print upright with no supports at 0.2mm layer height with three walls for optimal strength. Requires 2 "9 mm Small Thread, Plain Head, T-Bolt" to mount to your Multiboard, which may be obtained from "Keep Making" on Thangs.
Comment & Rating (17)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
I was going to mount it on my multiboard but it actually worked out perfect to mount to my shelf. 😁
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
great
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
perfectly printed with no issue
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Turned out very well. A bit tricky for big fingers to screw in the T Bolts, but once in place, it feels solid. It securely held either a 12' (pictured) or heavier 30' tape measure.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Love it. a wee tad awkward to get the screw in but works well
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld