This is a wall mounted bracket designed to hold 3/4" (inside diameter) PVC pipe. I loosely modelled my design off of "awlogue"s design:
Unfortunately my printers print bed was too small so I made my own with a couple additions.
Each "wall mount" can be used as an end or center piece. Additionally the "divider" part can be used to sort different discs. The "cap" part is made to snuggly fit inside each end of the PVC pipe and can be glued in place to prevent the pipe from sliding out.
Printer:
Anycubic i3 Mega
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20
Filament:
3D Solutech PLABlack
Category: Sport & Outdoors