Poop Chute (Snaps in place) by radupersoiu

radupersoiu

3D Printer>3D Printer Accessories

Print Profile(6)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 2 walls, 15% infill

Designer

4.8 h

1 plate

4.8(4)

Bigger Version

Designer

3.4 h

1 plate

Bigger Version for Anti-Vibration Feet

Designer

3.9 h

1 plate

Fit test (Print to test the tolerance)

Designer

15 min

1 plate

Click to see more

Open in Bambu Studio

Boost

Released

Description

3 Versions:

Small Poop Tray
Big Poop Tray
Bigger Poop Tray - This is only usable as long as you have the Anti Vibration Feet

I wanted a poop chute made from 2 different parts, one of which to be removable.
I was also avoiding using magnets, so here is an easy snap in system for it.
I wanted the slider to be attached using the original screws.
This model does not require any sort of supports.
0.16mm layers would do the trick for the angle, zero sagging.

poop chute

printer accessories

Comment & Rating (5)

@uzuniita

Print Profile

0.16mm layer, 2 walls, 15% infill

print without problems and absolutely NO problem !! I haven't mounted it yet because I thought the filament collector could be removed simply by lifting it, but does not allow easy emptying. I haven't assembled it yet but I'm thinking about using magnets so that all I have to do is lift the slide up edit: i see and 3° file look like an connector but i print the First profile with the 2 Pieces and if i assemble its not mooving up like you said, this 3° piece Is needed??

(Edited)

The designer has replied

@radupersoiu

Hi, If you are reffering to the 15 minute print file is to check the tolerance on your printer with minimum waste. That is a test to check if it fits your likeing before printing the whole file.