Heart-box
Copyright Claim
Heart-box
Boost
53
75
14
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4 h
1 plate
Open in Bambu Studio
Boost
53
75
14
0
146
119
Released
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
the lid was very tight, reduced it by 1mm on x and y so it is loose.
0
Reply
Thank you, I noticed that too. I was wondering how to make it better.
0
Reply
this profile doesn't work, overhang fails
0
Reply
flip the box lid will make it support-free printing.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Hezký model, nastavení tisku jsem nechal tak jak bylo od vás nahrané a jediné co bych přidal tak by byla podpora na víčko srdíčka kdy to začne tisknout do vzduchu a dělá to špagety. jinak moc pěkné.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I didn’t think about it but it’s a good idea so do ironing on the top of the lid since it prints up
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:needs proper support
0
Reply
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Related Models
© 2024 MakerWorld