Invisalign Case - No Hinge

Invisalign Case - No Hinge

Boost
28
45
17

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 2 walls, 30% infill
0.2mm layer, 2 walls, 30% infill
Designer
2.7 h
2 plates
4.8(13)

0.12mm layer, 2 walls, 30% infill
0.12mm layer, 2 walls, 30% infill
2.3 h
1 plate

Open in Bambu Studio
Boost
28
45
17
4
107
95
Released

Description

A replacement case for Invisalign or other retainers/dental inserts.

Rather than a clamshell design, this case is printed in two separate parts and is held together by four 5x2mm magnets. I've dropped this case a few times already and can happily report that the magnets held the case shut, preventing my retainers from falling on the ground.

 

You'll need to print two halves. I've included a version with no logo in case you want the Invisalign logo just on top, or if you want a generic case with no logo at all which can be used for retainers or other dental inserts. I personally like having the logo on both sides.

 

I've also created a little spacer file that can be used to make sure the magnets are closer together, as the ones I bought seem to sink a bit too low into the case for the hold to be strong. I used one spacer in each hole in one part of the case and two spacers in each hole in the second, and that makes it so the magnets are the perfect distance from each other to ensure a strong hold. You might need to play around to find the correct amount (if you need any at all) and that will depend on your printer and its settings.

Comment & Rating (17)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 30% infill
It came out pretty good!
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
printed great on the defult build plate, but tried to use a high temp/make a design build plate it didn't work at all.
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
the logo could use some support but great fit!
0
Reply
What size magnets would you need?
The designer has replied
0
Reply
5x2mm
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
Flawless print. Everything's fine. The magnetic mount works very well thanks to the spacers.
Show original
0
Reply
I'll add a Photo after my magnets come in but the design is gorgeous and simple. I do agree with someone who posted earlier that the design needs supports to print smooth, but I'm just going to put something over the top to give a gem/stone like appearance.
0
Reply
Looks Great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply