Heyho

I recently installed some electronics to my friends van.

To give him some spare fuses next to the electronic devices I designed this fuse holder.

You can insert

1 x MEGA- Fuse (megaOTO)
3 x Midi- Fuse (midiOTO)
4 x Standard Car Fuses (normOTO)

To mount the Holder to a wall I used two 3 x 20 mm screws.

Additional you may use two M3 x 10 mm Screws to secure the midi- and mega Fuses. But I did not need to do that since they should not fall out of the holder.

Note: If you have not the best tolerances with your printer you might want to scale the Model up about 2% so you don´t have trouble to load the fuses into the holder. But I didn´t test that yet since My holder works perfect as it is!

Have fun and keep printin!