Laptop And Keyboard Stand
Copyright Claim
Laptop And Keyboard Stand
Boost
147
231
27
Print Profile(2)
0.24mm layer, 2 walls, 15% infill
Designer
2.6 h
3 plates
ABS 0.2mm layer, 3 walls, 15% infill
3.8 h
1 plate
Boost
147
231
27
3
443
338
Released
Description
Use this stand for best organize your desk
Comment & Rating (27)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Strength Issue:The design is verden pretty, that was why i choose to print it. But the middel pease is to week, and is not steady enough. it wlll break over time. it needs a lot of glue to be assembled.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
I really like the idea of this design and how it's supposed to look, but it just doesn't go together as nicely as I would like. I ended up trying to weld it together and that turned into a mess. The inner connectors are too small and it printed just a hair off. Maybe that could be the difference in our printers though. I really do appreciate the design though, just wanted to leave some hopefully helpful feedback.
The designer has replied
0
Reply
Thank you so much for your opinion, I will work on it!
(Edited)1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
good print but has to be clamped for gluing, the tab that connects one part to the other is too small
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
too wobbly
1
Reply
Wobbly and not great, I did rearrange to fit on a single place but the front section seems poorly thought out. Quite a nice shape but just really too wobbly to recommend.
1
Reply
nice design, but tolerances need to be tighter for insert as they are very loose which causes issues while trying to glue together.
0
Reply
Print Profile
ABS 0.2mm layer, 3 walls, 15% infill
Thanks. Needs a support bar in back and the tabs on the front cross bar are smaller than the holes in the stands, so they require a lot of glue.
0
Reply
Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
very nice, Thank you!!! I print this with 0.16 and Spectrum ASA-X CF10
It looks like original Apple design!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
cool design but botom part is very thin and dont fit well with the two big parts
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld